1975 Chevy Monza NHRA Super Gas Super Pro drag race car

  
Steel roof and upper quarter panels. Zus retainers on all panels. Jerry Bickel rear wing with struts. Five point seat belt harness. JAZ three gallon fuel cell.

JAZ one quart gasoline fuel bottle. Q-A1 adjustable coil over front shocks. Four link wishbone rear suspension. Strange engineering coil over adjustable shocks. Dart Little "M" Block w/4 Bolt Splayed Caps.

Eagle 4340 6.000 H-Beam Steel Rod. Wiseco 14.25 Gas Ported Pro Series Forged Pistons.

SSRE Custom Grind Steel Billet Roller Cam. Comp Cams Heavy Duty Solid Roller Lifters. Rollmaster Billet Timing Set w/IWIS Chain & TorringtonBearing.

Brodix Fully Hand Ported Aluminum Heads. 1.550Roller Springs w/Titanium Retainers & 10° Locks.

Comp Cams roller rockers w/ Titanium Pushrods. Super Victor Race intake drilled for fuel injectors. Ron's toilet alcohol fuel injection. Electric gasoline priming pump kit.

Oil pan with wind-age tray. Moroso Vacuum pump w/breather tank. Hooker super comp headers 1 1/2 primary's. Front & rear solid mount engine plates. Dual Optima deep cycle batteries 12v. MSD pro billet distributor w/bronze gear.

MSD 8.5mm ignition wires. MSD 7AL-2 pro ignition box.

MSD two step rev limiter. 1.80 steel planetary gear set. TCI SFI aluminum trans shield. Hughes 5500 rpm stall convertor. Strange engineering Nodular iron center section. 4.71 gear ratio mounted on spool. Moser axles with 5/8 wheel studs. This item is in the category "eBay Motors\Other Vehicles & Trailers\Race Cars (Not Street Legal)\Drag Racing". The seller is "firstchoiceauto" and is located in this country: US. This item can be shipped to United States.

1. Model Year: 1975
2. Vintage Racer: No
3. Modified Racer: Yes
4. Model: Monza
5. Make: Chevrolet